Session Status

Due to inactivity, your session will end in approximately 2 minutes. Extend your session by clicking OK below.

Due to inactivity, your session has expired. Please sign in again to continue.

Orbic SPEED X 5G
Advanced Settings

2026-10-15 11:14:27.759

Orbic SPEED X 5G
Advanced Settings

Configuring advanced settings (e.g., networks, manual DNS, etc.) on your Orbic® SPEED X 5G allows you to optimize performance, internet speed and connection reliability.

Before you begin

Changing advanced settings may be harmful to the stability, performance, and security of your Orbic SPEED X 5G. Contact your local IT admin before changing any of these settings.
For info regarding APN settings, refer to Edit Access Point Name (APN).
Domain Name Server (DNS) settings are automatically assigned by the device. If turning on manual DNS is necessary, contact your local IT admin for assistance.
When an OpenVPN tunnel is established, all connected device traffic is sent through the tunnel and settings such as Port Forwarding and Port Forwarding don't apply.

Networks

  2. From the Settings section, click the
    Arrow icon
    .
  3. From Settings, click the
    Advanced
     tab.
  4. Review the warning message then click
    Continue
    .
  5. From the Cellular Network Technology section, click the following to turn on or off.
    • Allow device to connect to the mobile network while roaming
    • Enable automatic network selection
  6. Click
    Select Network Manually
     to manually choose a network.
    Ensure Enable automatic network selection is turned off.
    Auto is the preferred setting.
  7. Click
    Save Changes
    .

Manual DNS

  2. From the Settings section, click the
    Arrow icon
    .
  3. From Settings, click the
    Advanced
     tab.
  4. Review the warning message then click
    Continue
    .
  5. Click the
    Manual DNS
     tab.
  6. Click
    Turn on Manual DNS
     to turn on.
  7. From the DNS 1 IP address and DNS 2 IP address fields, enter the applicable info.
  8. Click
    Save Changes
    .

LAN

  2. From the Settings section, click the
    Arrow icon
    .
  3. From Settings, click the
    Advanced
     tab.
  4. Review the warning message then click
    Continue
    .
  5. Click the
    LAN
     tab.
  6. Click
    Turn on DHCP switch
     to turn on or off.
  7. Enter the desired info into the following fields:
    • IP Address
    • Subnet Mask
    • DHCP lease time
    • Start DHCP Address Range at:
    • End DHCP Address Range at:
  8. Click
    Save Changes
    .

VPN

  2. From the Settings section, click the
    Arrow icon
    .
  3. From Settings, click the
    Advanced
     tab.
  4. Review the warning message then click
    Continue
    .
  5. Click the
    Firewall
     tab.
  6. Click the
    VPN Passthrough switch
     to turn on or off.
  7. Click
    Save Changes
    .